More Information
							Wallint 50 is an air barrier and vapour control layer for use on the warm side of the insulation. It has a vapour resistance of 250MNsg, meeting the requirements of BS 9250 (Code of Practice for the design of the airtightness of ceilings in pitched roofs). The air barrier and vapour control layer prevents large volumes of water vapour from entering a construction from the interior, particularly during the drying-out period, whilst providing additional support for insulation boards or quilts.
For clarification consideration must be given to the intended use and height of the building based on the fact that the reaction to fire performance of the product is Class E in accordance with EN 13501-1. For further information contact your Principle Designer, the relevant Building Control Authority or the relevant guidance document such as Approved Document B for England.
						 
						
							Specifications
															
									
										
										
										
											Packaging
	
		
			Number of Pieces per Carton/Pack 
			1
		 
	 
	
		
			Number of Pieces per Pallet 
			20
		 
	 
	
										 
									 
						     
				        							 
						
							
								
													    
    							Installation
							    
    								- Before Wallint 50 is installed, check the moisture content of the timbers is less than 20%. Fix on the warm side of the installation and rafters  with the printed smoother surface facing inwards
- At either edge of the structure, leave a 150mm overlap to allow Wallint 50 to be sealed to adjoining walls
- Roll-out with a horizontal headlap of 150mm. Fix to rafters/ceiling joists using non-corrosive fixings eg staples. Ensurelaps are sealed using a tape such as Permo TR
- Where pipes pass through use a Klober Pipe Sealing Collar and tape edges to Wallint 50 to achieve an airtight seal
- Wallint 50 should cover the entire internal timber frame  area of the rooms in the roof and, where applicable, link with vapourcontrol layer in the wall below to form a continuous air barrier
 
    					    
													    
    							Area of application
							    
    								- The inner face of an insulated roof, wall* or ceiling, including timber frame
- Suitable for cold and warm roofs
- *Please refer to note on the Information tab
 
				    									 
						 
						
							
							
		
	    
Standards and Certifications